User guide

A 0> prompt indicates that you have successfully entered Monitor Mode and looks like
this:
Monitor Mode (Telnet)
You can perform the following actions, observe upper-case where shown.
VS x.x.x.x Version
Queries software header record (16 bytes) of
unit with IP address x.x.x.x.
PI x.x.x.x Ping
Pings unit with IP address x.x.x.x to check
device status.
AT ARP Table Shows the unit’s ARP table entries.
TT TCP Connection Table
Shows all incoming and outgoing TCP
connections.
NC Network Connection
Shows the unit’s IP configuration - IP
address, Subnet Mask & Gateway where
applicable. Note: if the user has fixed these
parameters then they may not be an accurate
reflection of the real-time status on the LAN
RS Reset Resets the unit’s power.
QU Quit Exits diagnostics mode.
Note: Entering any of the commands listed above generates one of the following command
response codes:
Command Response Codes
8 Appendix C - Reloading Firmware
There are two ways to update the unit's internal operational code (*.ROM): via
DeviceInstaller (the preferred way) or via TFTP. You can also update the unit's internal Web
interface (*.COB) via TFTP or DeviceInstaller.