User guide

I/O (GPIO). You may want to disable this capability for security purposes. The default setting

is the N (No) option, which enables GPIO control. The Y (Yes) option disables the GPIO

control interface.

Note: As these pins are presented through n RS232 line driver IC it is not possible to change

the ‘direction’ of these pins on standard variants of NetPort.

6.7 Factory Defaults

Select 7 to reset the unit’s Channel 1 configuration, e-mail settings, and expert settings to the

factory default settings. The server configuration settings for IP address, gateway IP address,

and Netmask remain unchanged. The configurable pins’ settings also remain unchanged. The

specific settings that this option changes are listed below.

Channel 1 Configuration Defaults

Expert Settings Defaults

Security Settings Defaults

Exit Configuration Mode

You have two options:

• Select 8 to exit the configuration mode without saving any changes or rebooting,

• Select 9 to save all changes and reboot the device. All values are stored in nonvolatile

memory.