User guide

• Run HyperTerminal from the Accessories\Communications menu.
• Select TCP/IP (Winsock) mode from the pull-down menu.
• Enter the IP Address of your NetPort and 10001 for the port number:
If HyperTerminal does not successfully connect, check that you have entered
the IP address and Port number correctly. Additionally, check that the
NetPort settings match the baud rate and port number you have entered in
HyperTerminal.
5.2 If you have an application already which can talk to a TCP/IP
Socket
You need to configure your Application to use Socket (Port) number 10001 and ensure this is