Specifications

Page 28 Installation Instructions: Roadrunner 030 & 040 AM-1000 / AM-1200 Upgrade
6-32 PHILLIPS-HEAD
SCREW
TOWARD FRONT
PANEL
TOWARD REAR
PANEL
AM-17X MOUNTING
BRACKET
(DWF20349-01)
MAC930
#6 NYLON
WASHER
By installing shorter standoffs on the
rear of the tape or diskette drive, it will
lower the AM-17X board, allowing the
SIMM memory card to clear the bottom
of the AM-177 or AM-167 board.
1" STANDOFFS INSTALL
AT THE FRONT OF THE
DRIVE
7/8" STANDOFFS INSTALL
AT THE REAR OF THE DRIVE
Roadrunner Board Mounting
5.With the completed assembly properly positioned inside the chassis, install the
four screws through the bottom of the chassis that hold the assembly in place.
Before you power-up your computer, make sure the top edge of the
Roadrunner board’s SIMM card is no higher than 4-1/8" above the chassis
bottom; this will prevent the SIMM card from making contact with the AM-167 or
AM-177 board.
PDI-00172-10, Rev. A03