Specifications
Page 22 Installation Instructions: Roadrunner 030 & 040 AM-1000 / AM-1200 Upgrade
11.0INSTALLING THE ROADRUNNER BOARD
There are several different methods of installing the Roadrunner board. In a typical
installation that includes a new SCSI drive, the Roadrunner board will be mounted
above the SCSI disk drive using the PDB-00172-10 mounting kit. If you choose to use
your existing disk drive, the Roadrunner can be mounted in the center position between
the power supply and the hard disk drive. It can be also be mounted in the center
position on top of a half-height floppy or Tandberg streaming tape drive, using special
brackets included in your PDB-00172-11 mounting kit.
11.1Mounting the AM-172 Above 3-1/2" SCSI Drive
If you included a new 3-1/2" SCSI drive with your Roadrunner upgrade, a special
bracket (DWF-20741-00) is included for mounting both the disk drive and the
Roadrunner board. The following instructions describe how to build the bracket, drive,
and Roadrunner board assembly:
1.Unplug any interface or power cables attached to your old disk drive assembly.
2.The two mounting brackets holding your old disk drive in place set on top of four
nylon standoffs. The brackets are attached to the standoffs with four phillips-head
screws. Remove the screws, but leave the nylon standoffs in place.
3.After the screws have been removed, your old disk drive assembly can be
removed from the chassis.
4.The new mounting bracket, the new SCSI drive, and the Roadrunner board must
be assembled together, before being installed in the chassis.
PDI-00172-10, Rev. A03