Owner`s manual
Page A-6 Appendix A
SCSI
SCSI
(PRA-00222-00)
EXTERNAL SCSI BUS
TERMINATOR
CONFIGURATION B
CONFIGURATION A
BAIL LOCKS
MAC821
#4 SCREW
AND WASHER
External Terminator Installation
The above illustration shows two different types of external SCSI connectors:
1.Configuration"A" shows an extended external SCSI connector and bail
locks for holding the terminator in place. This configuration is used on
almost all of Alpha Micro’s currently available product. The terminator is
installed by sliding it over the connector and then latching the bail locks
into the notches in the terminator.
2.Configuration"B" shows a flush mounted external SCSI connector. The
only product Alpha Micro currently offers using a flush mounted external
SCSI connector is the pedestal (also known as the "Classic") chassis. In
this configuration, the terminator inserts into a cutout in the sheet metal
and over the SCSI connector. The terminator is held in place with two
#4screws and washers.
PDI-03500-50, Rev. B00