Specifications
Page 21Installation Instructions: Roadrunner 030 and 040 AM-2000M Upgrade
11.Once the AM-986 board is properly seated in its connector on the AM-145 board,
install the 4-40 nylon screw as indicated. Do not over tighten the nylon screw.
12.Install the phillips-head screw that secures the AM-986 mounting bracket to the
AM-145 board.
10.0INSTALLING YOUR ROADRUNNER BOARD
Before you install your Roadrunner, make sure the board is configured properly for your
configuration. The AM-174 and AM-172 jumper configuration drawings explain the
function of each jumper.
Use the following instructions to install the Roadrunner:
1.A bracket (DWF-20748) designed for mounting the Roadrunner board is included
in the installation kit. To install the bracket, you must remove the four phillips-head
screws shown in the illustration.
2.After the screws have been removed, install the DWF-20748-00 bracket as shown
in the illustration. The bracket is held in place with four 1.5 inch 6-32 phillips-head
screws (included in the installation kit).
3.Install the Roadrunner on its mounting bracket. Make sure it is oriented exactly as
shown. The Roadrunner board is held in place with four 6-32 phillips-head screws.
If you have an "A" revision AM-172 board, one of the screws requires a #6 nylon
washer (shown in the illustration), which protects a surface mount resistor on the
Roadrunner board.
PDI-00172-40, Rev. A05