Service manual

Page 4 AM-6060 Service Manual
Rev. A00
HARDWARE CONFIGURABLE OPTIONS
The following sections summarize the configuration options available to let you tailor your hardware to
your needs. These options require access to the main circuit boards inside the computer, and should be
performed only by qualified technical personnel. Contact your VAR if you need assistance.
Printed Circuit Board Configuration
The next few sections contain configuration information for the AM-301-10 and AM-176 boards
AM-301-10 Board Configuration
The AM-301-10 board supports the four serial ports in the AM-6060. It also contains your computer's
SSD chip, real-time clock, and other I/O related circuitry.
Figure 4 shows the AM-301-10 board configured as shipped by Alpha Micro. (The illustration does not
show all components on the board.) Field-configurable jumpers are noted on the figure and described
after it. All other jumpers should be left in their factory configured positions.
J1
PIN 1
J2
P1
P2
+
+
U11
SSD
SOCKET
TO FRONT PANEL
DISPLAY
TO AM-90 AND
SERIAL PORTS
MADE IN U.S.A.
RESET
JP4
JP5
JP7
JP6
XCLK BCLK
P3
AC POWER FAIL CONNECTOR
ATTACHES TO JP6
OPTIONAL REMOTE
RESET CABLE
ATTACHES HERE
CONNECTORS ON SOLDER SIDE
AT P1, P2 AND P3 CONNECT TO AM-176
ENABLES LEVEL7 THROUGH TURBO BUTTON
Figure 4: AM-301-10 Board Configuration