Service manual

AM-6060 Service Manual Page 3
Rev. A00
Figure 3: Static Protection Wrist Strap
BOARD VERSIONS AND COMPATIBILITY
Only certain versions of the AM-176 CPU board can be used in the AM-6060. Specifically, the AM-176
must be Rev. C04 or later, with boot PROMs (DWB-00176-10) Rev. B00 or later.
The front panel display board in the AM-6060 must be the AM-966-10. No other front panel display
board is supported.
REPLACING THE AM-301-10 BOARD
The AM-301-10 board plugs directly into the AM-176 board; it is not attached by cables. If you need to
remove and replace it, there are connectors on the AM-301-10 at locations P1, P2, and P3 which plug
into the AM-176 at P4, P6, and J6.
When connecting the AM-301-10, be sure to align the connectors properly. To ensure proper alignment,
the P1 connector has a keying bump on it. Plug this connector in carefully,
without forcing
, and the
bump will ensure proper alignment of all connectors.