Service manual

AM-6060 Service Manual Page 1
Rev. A00
INTRODUCTION
The instructions in this document are intended only for authorized service personnel. AM-6060
computers contain a high-output power supply, which produces current levels high enough to
make it unsafe for unauthorized persons to perform work inside the chassis.
This document describes the following procedures and topics for the AM-6060 computer:
•
Removing your computer's cover and electronic equipment handling precautions
•
Board versions and compatibility
•
Replacing the AM-301-10 board
•
Configuration options for the AM-301-10 and AM-176 boards
•
Connections to the AM-966 front panel display
•
Installing memory
•
Peripheral installation
ACCESSING YOUR COMPUTER
When adding additional equipment or servicing your computer, you will need to remove your computer's
top cover. The top cover is held in place with four Phillips-head screws on the computer's rear panel. To
remove the top cover, remove all four screws from the locations indicated in Figure 1. Once the screws
have been removed, you can slide back and remove the top cover, as shown in Figure 2.
OTHER BACK PANEL
CUTOUTS ARE NOT
USED BY THE AM-6060,
AND ARE COVERED.
TOP COVER SCREWS
115
Figure 1: Chassis Top Cover Screws