Service manual

AM-6060 Service Manual Page 9

Rev. A00

The SSD chip on the

AM-301-10 and the

boot PROM on the

AM-176 board

require a

specialized tool for

their removal. If

you attempt to

remove the SSD

chip or boot PROM

using a screwdriver or

pocketknife, you could

easily damage both the

chip and the socket. This

type of chip extraction tool

is available at retail stores

specializing in electronic

components.

WARNING!

Figure 7: SSD Chip Removal Tools

AM-966-10 CONNECTIONS

The AM-6060 uses the AM-966-10 front panel display board, which connects to the AM-301-10. In most

cases, you should not need to connect any wires to or disconnect any wires from the AM-966. However,

if any of your front panel display lights stop working, or if one or more wires come loose from the AM-

966, you can refer to the picture and list below to check and, if necessary, remake any connections.

PIN 1

EN20

EN26

JP3

THIS JUMPER MUST

BE IN THE TOP POSITION

DWB0966-10 Rev xxx

JP6

JP1

JP5

TURBO RUN

DISK

TURBO SW

JP4

SPKR/PWR

RESET

JP2

CABLE FROM 301-10

PLUGS IN HERE

Figure 8: AM-966-10 Board Layout