Owner`s manual

Page 5-12 Chapter Five
AM-6060 Computer Owner's Manual, Rev. 00
DSKANA DSK1:
RETURN
[Begin analysis of DSK1:]
[1,2]
.
[100,20]
[The following blocks were marked in use but not in a file]
1767 1772 2562 3456 6265
[The following blocks were in a file but not marked in use]
[Rewriting BITMAP]
No file errors
If you see the "No file errors" message, the file structure on the disk is intact. If DSKANA lists a number
of file errors, there is a problem with the disk's file structure. Your next step is to run DSKANA again,
using either the /L or /E option—discussed below—to see where the errors are on the disk.
For the complete procedure to follow if DSKANA finds any file errors, see "Recovering From Disk
Errors" in the
System Operator's Guide
.
DSKANA Options
Following are the most common DSKANA options. Please see the DSKANA reference sheet in the
System Commands Reference Manual
for a complete listing of options.
Option Function
None Displays account numbers on disk and summary only.
/C Same information as default, but does not rewrite bitmap.
/E Lists files and blocks in which any errors occurred.
/L Lists all files and blocks on the disk.
To use one of these options, place it after the DSKANA command like this:
DSKANA DSK1:/C
RETURN
As mentioned above, you need to use the /L or /E option to find the location of any file errors DSKANA
detects. The /C option is discussed in the next section.
To see the list of DSKANA options, type
DSKANA
RETURN
without specifying a device name.