Owner`s manual

System Administration Page 5-5
AM-6060 Computer Owner's Manual, Rev. 00
VUE TEST.INI
RETURN
If you are unfamiliar with AlphaVUE, refer to the
AlphaVUE User's Manual
.
4. Make all the necessary changes to TEST.INI. Save the file when exiting AlphaVUE by pressing
the
ESC
key and typing
F
. Some of the common changes you may want to make are discussed
below.
5. Use MONTST to insure TEST.INI is working as expected. Make sure no one else is using the
computer, then type:
LOG OPR:
RETURN
MONTST ,TEST.INI
RETURN
6. After you have successfully tested TEST.INI and you are satisfied with the results, copy it back
to AMOS32.INI, AM6060.INI or whatever name you choose for your “live” initialization file.
Follow this procedure any time you modify the system initialization file.
Be careful not to rename your TEST.INI file too soon. You might want to let the computer run
awhile to test out the new configuration before you rename it. Then, if you decide you don't want
to keep the new configuration, you can always press the Reset button to reboot with your former
system initialization file.
Do not change any lines in the system initialization file other than those discussed below until
you're familiar with the documentation on the file in the
System Operator's Guide to the System
Initialization Command File
.
Here is a sample simple initialization file: