Owner`s manual

Troubleshooting Procedures Page 7-9
AM-6000 Computer Owner's Manual, Rev. 00
G. Observe the front panel Status Display and the screen.
If a blinking error code appears on the front panel Status Display, check it off on the Self Test
Checker.
As each test finishes, note whether the component being tested passed or failed.
If an error occurs during the Memory Test, the addresses of the errors display on the screen. Jot
them down on the Self Test Checker.
H. Stop the self test at an appropriate time.
After the self test finishes testing all the devices
, wait until it's performing the system
configuration inventory again and press the reset button to end the test.
There is a slight chance you might damage the data on the disks if you interrupt the test
while it is testing one of the storage devices.
If the test loops on the configuration test
and stays on error code 80 or 8F and won't go further,
press the reset button to stop the test.
If the test loops on the memory test
, and stays on a memory error code and won't go further, press
the reset button.
I. If errors were found, call your VAR for help.
To find out what the blinking number you circled or recorded means, refer to your
Self Test User's
Guide
.
Be sure to keep your Self Test Checker, since that information will be of help to your VAR.
J. If the self test didn't find a problem, return to the current troubleshooting procedure or perform the
next procedure on your checklist.
Configuration Test Memory Test Interval Timer Test
Steady Blinking Steady Blinking Steady Blinking
80 90 98
80 9X/1/16* 98
5b 8F/1-16*
8F 8F
Table 7-1: Self Test Checker (1)