Instruction manual

MAKACD Page 2
System Commands Reference Manual, Rev. 11
OPTIONS
/HELP Display the available options and exits
/? Same as /HELP
/V Display version information and exits
/COUNT:n Creates n CDs containing the same data
/DEV:xxx: Uses device and driver named xxx: instead of the default CDR:
/EJECT Ejects the CD in the recorder and exits
/ERASE:ALL Erases the entire rewritable CD by overwriting all data areas on
the CD.
/ERASE:QUICK Erases the rewritable CD by clearing only the control information
without actually overwriting the data areas of the CD. This
causes the CD to react like a blank CD when read or written. Do
not use this switch if the rewritable CD contains more than one
session.
/ERASE:SESSION Erases the last session from a multi-session rewritable CD by
overwriting all data areas of the last recorded session on the CD.
This command may be used more than once to successively erase
multiple sessions from the CD. Once a session is erased, the
previous session may become available.
/ID:n Uses the CD-Recorder at SCSI ID n instead of scanning the SCSI
bus to find a CD-Recorder. The ID can be from 0 to 15.
/NOEJECT The CD will not be ejected from the recorder.
/NOFILL Do not write AMOS filler and ACD special sector information.
The newly recorded data will not be accessible by the ACD
program.
/NOTOC Do not write out the table of contents when recording is finished.
The newly recorded data will be inaccessible until the /TOC
option is used to write the table of contents.
/PIC Displays the Product Installation Code
/SPEED:n Sets the maximum recording speed to n times the normal audio
speed. This switch can be used to force recording at a slower
speed if the system is unable to supply data to the CD-Recorder.