Specifications

12
We reserve the right to modify technical specifications without prior notice.
UK830301/170306 © Alpha-InnoTec GmbH
installation of the module box
The entire cooling circuit of the heat station is contained in
the module box.
CAUTION.
Do not tilt the module box more than a ma-
ximum of 45° (in any direction).
Place module box in front of the unit.
1 Unit
2 Plug for electrical connection
3 Front edge of bottom of unit
4 Module box
Use straps to lift module box and initially place in
unit so that the rubber feet of the module box that
are facing the unit come to rest on the centering
plate behind the front edger of the bottom of the
unit.
Push module box into the unit until the front rubber
foot of the module box contacts the front edge of
the bottom of the unit and has to be lifted over it.
When pushing in the box, make sure that the plugs
for the electrical connection are not pinched and
damaged.
Raise module box, push it further into the unit and
lower the box as soon as the rubber feet contact
the corresponding stops of the centering plate.
Set the front left rubber foot of the module box
between the guide elements.
The module box is positioned correctly in the unit when the
rubber feed are placed as shown in the following sketch:
WZS 60…:
1 Stops on centering plate
2 Rear rubber feet of module box
3 Centering plate for module
box on bottom of unit
4 Front rubber foot of module box
5 Guide element
WZS 80… and WZS 100…:
1 Stops on centering plate
2 Rear rubber feet of module box
3 Centering plate for module
box on bottom of unit
4 Front rubber feet of module box
5 Guide element