Specifications

28
We reserve the right to modify technical specifications without prior notice.
83053100bUK © Alpha-InnoTec GmbH
Next, on the opposite side, moving upwards.
Lock the screen’s snap-in lugs in place in the slots
provided on the front of the facade…
Finally, press the screen’s upper snap-in lugs into
the slots provided on the front of the facade.
removing the screen
In order to remove the screen, the snap-in lugs must
rst be loosened by pressing one side completely
toward the middle of the screen. Thereafter,
remove the snap-in lugs from the opposite side.
Installation of the room
thermostat for the cooling
function
This chapter is relevant for you only if you are using a
heat station with a model designator K.
ATTE NTION
If oor heating systems are to be used for
cooling, the manufacturer must approve
the oor structure (especially the screed)
for use of the cooling function.
Use the room thermostat of the cooling function in a
reference room as a reference variable. If the tempera-
ture in the reference room falls below the set temper-
ature, the cooling function of the heat station will auto-
matically shut off.
Operating manual of the heating and heat pump
regulator, “Cooling” chapter.
NOTICE.
You must install the room thermostat in
a reference room in addition to single-
room regulators.
You must install single-room regulators for
switching from heating to cooling (and vice
versa).
NOTICE.
Always comply with the applicable local
standards and directives.
Hot-water tank
The integrated hot water tank is enameled according to
DIN 4753 and is suitable for normal drinking water.