Specifications
4
We reserve the right to modify technical specifications without prior notice.
83050800aUK – Translation of the operating manual  © Alpha-InnoTec GmbH
Intended use
The unit is only to be used for its intended purpose. This 
means:
•
 for heating.
•
 for domestic water heating.
The unit must be operated only within its technical 
parameters.
  “Technical data / scope of supply” overview.
 NOTE.
  Notify the responsible power supply company of 
the use of a heat pump or heat pump system.
Disclaimer
The manufacturer is not liable for any damage or losses 
resulting from use of the unit which is not its intended 
use.
The manufacturer's liability also expires:
•
 if work is carried out on the unit and its 
components contrary to the instructions in this 
operating manual.
•
 if work is improperly carried out on the unit and 
its components.
•
 if work is carried out on the unit which is not 
described in this operating manual, and this 
work has not been explicitly approved by the 
manufacturer in writing.
•
 if the unit or components in the unit have been 
altered, modied or removed without the explicit 
written consent of the manufacturer.
EC conformity
The unit bears the CE marking.
  EC Declaration of Conformity
Safety
The unit is safe to operate for its intended use. The 
construction and design of the unit conform to current 
state of the art standards, all relevant DIN/VDE 
regulations and all relevant safety regulations.
Every person who carries out work on the unit must 
have read and understood the operating manual before 
starting any work. This also applies if the person 
concerned has already worked with such a unit or a 
similar unit or has been trained by the manufacturer.
Every person who carries out work on the unit must 
comply with the relevant local accident prevention and 
safety regulations. This especially applies to the wearing 
of personal protective clothing.
 WARNING!
  Risk of fatal electric shock!
  Electrical connection work must be 
carried out by qualied electricians only.
  Before opening the unit, safely disconnect 
the system from the power supply and 
prevent it from being switched back on!
 WARNING!
  Only qualied personnel (trained heating, 
refrigerating system and refrigerant 
engineers and electricians) may carry out 
work on the unit and its components.
 WARNING!
  Note and follow the safety stickers on and 
in the unit.
 WARNING!
  Unit contains refrigerant!
  Leaking refrigerant could result in 
personal injury and environmental 
damage. Therefore:
–  Switch off system.
– Thoroughly ventilate installation 
room.
–  Notify the manufacturer’s authorised 
service centre.
 IMPORTANT
  For safety reasons:
  Never disconnect the unit from the power 
supply, unless the unit is being opened.










