Specifications

We reserve the right to modify technical speciﬁcations without prior notice.

UK830300/170717 © Alpha-InnoTec GmbH

NOTICE:

To remove the screen, release the snap-

in lugs in the reverse order, i.e. from top to

bottom, without the use of tools.

CAUTION.

The snap-in lugs have a tight t. Press rmly

from the side against the screen toward the

middle, so that the snap-in lugs do not break

off.

Installation of the room

thermostat for the cooling

function

This chapter is relevant for you only if you are using a heat

pump with a model designator K.

CAUTION.

If oor heating systems are to be used for

cooling, the manufacturer must approve the

oor structure (especially the screed) for use

of the cooling function.

Use the room thermostat of the cooling function in a refer-

ence room as a reference variable. If the temperature in the

reference room falls below the set temperature, the cooling

function of the heat pump will automatically shut off.

Operating manual of the heat pump and heating

regulator, “Cooling” chapter.

NOTICE:

You must install the room thermostat in a

reference room in addition to single-room

regulators.

You must install single-room regulators for switch

ing from heating to cooling (and vice versa).

NOTICE:

Always comply with the applicable standards

and directives.