User's Manual

User Manual
43
FCC Statement
Receivers associated with the operation of a licensed radio service, e.g., FM broadcast under part 73 of this chapter, land
mobile operation under part 90, etc., shall bear the following statement in a conspicuous location on the device:
This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause
harmful interference.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user ’s authori
ty to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
FCC RF Exposure information and statement
The SAR limit of USA(FCC) is 1.6W/kg averaged over on one gram of tissue.
Device types: ET1(FCCID:2AFAPET) has also tested against this SAR limit.
The highest SAR value reported under this standard during product certification for use at the ear is 0.311 W/kg and when
properly worn the the body is 0.811W/kg, This device was tested for typical body-worn operations. To comply with RF
exposure requirements, a minimum separation distance of 1.0 cm. must be maintained between the user ’s body and the
handset ,including the antenna. Third-party belt-clips, holsters and similar accessories used by this device should not
contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF
exposure requirements and should be avoided.
And Customers can view more product certification information from the website (
https://www.fcc.gov/)