User guide
Table Of Contents
ADM-XRC-5T2-ADV User Manual
ADM-XRC-5T2-ADV User Manual
1. Introduction
The ADM-XRC-5T2-ADV is a high performance PCI Mezzanine Card (PMC) designed for
supporting development of applications using the Virtex-5 FF1738 Family of FPGA Devices.
• Virtex5 LXT: LX110T, LX155T, LX220T or LX330T
• Virtex 5 SXT: SX240T
• Virtex 5 FXT: FX100T, FX130T, or FX200T
The card uses an FPGA PCI bridge developed by Alpha-Data supporting PCI-X and PCI. A
high-speed multiplexed address/data bus connects the bridge to the target (user) FPGA.
The card can also be fitted with a Primary XMC connector to provide high-speed serial links
to the user FPGA.
The board is an application specific version of the ADM-XRC-5T2 and features JPEG2000
video compression capabilities and multi-gigabit serial links using 2 FCN x4 Fibre Channel
connectors.
1.1. Specifications
The ADM-XRC-5T2-ADV supports high performance PCI-X / PCI operation without the need
to integrate proprietary cores into the FPGA.
• Physically conformant to VITA 42 XMC Standard
• Physically conformant to IEEE P1386-2001 Common Mezzanine Card standard (with
XMC connector removed)
• 8-lane PCIe / Serial RapidIO connections to User FPGA (via XMC connector)
• 8 additional MGT links to User FPGA. (via front-panel) A cost-effective solution to
applications requiring high-speed data communications such as Infiniband TA, 10G
Ethernet, 4x Fibre Channel and others.
• High performance PCI and DMA controllers
• Local bus speeds of up to 80 MHz
• Up to four independent banks of 64Mx32 DDRII SDRAM (1GB total)
• Two banks of 2Mx18 DDRII SSRAM (8MB total)
• User clock programmable between 31.25MHz and 625MHz
• Stable low-jitter 200MHz clock for precision IO delays
• User front panel gigabit serial I/O – 8 lanes in 2 FCN connectors
• 4 JPEG2000 codecs (Analog Devices ADV212) which can be operated individually or
in 2 tandem banks to provide compression /decompression of video data
• User rear panel PMC connector with 32 free IO signals
• Programmable I/O voltage rear interfaces
• Supports 3.3V PCI or PCI-X at 64 bits
Version 1.0
Page 1