User Guide

Connecting Water Supply
1. Close the water supply valve. Flush toilet.
2. Unscrew water supply hose from water tank.
Place towel below tank to catch any dripping
water.
3. Using finger nut, attach T-Valve to water
tank where you removed the water supply hose.
4. Re-attach water supply hose to bottom of
T-Valve.
5.
Connect the bidet supply hose to the metal
inlet on the side of the bidet seat. Connect
the other end of the hose to the T-Valve and
tighten snugly. Be careful not to over-tighten.
6. Slowly open the water valve to check if
there is any water leakage.
Unscrew to remove
Finger nut
5
7. Wipe the hoses and connectors thoroughly with a towel and carefully observe for any leaks for at least
10 minutes. Tighten any connectors gently until leakage stops. If any leaks continue, turn off water
supply and check hoses for damaged rubber o-rings. Teflon tape may be used on connections to help seal.
A L P H A O N E