User's Manual

2 / 7
a. Power On: Press and hold the power button until the blue light is on. It will keep
flashing while detecting GSM signal, and turns to steadily on for few seconds and then
turns off.
b. Power Off: Send command *poweroff* when the SIM is inserted.
If there is no SIM inserted, press and hold button until the blue light off.
c. Panic Button:Press and hold power button for 3 seconds to generate a SOS call alert
to the preset emergency number. No indicating light will be on.
d. Charge: The blue light is steadily on during charging and turns off when it is fully
charged.
If threre is no LED light on, keep charging for 20 minutes and then press and hold the
button to turn on the device, you will see BLUE LED light flashing and then turn to steadily
on, and will turn off when fully charged.
4. Operation Commands Guide
4.1 Set APN: (VERY IMPORTANT AND MUST BE DONE 1ST) For the device to send
data to the server, this command MUST be enabled.
SMS: *apn*AXXX*BXXX*CXXX* This command sets the telecom Access Point Name.
BXXX refers to user name, CXXX refers to password.
If there is no user name and password required, send as *apn*AXXX*
If there is user name but no password required, send as *apn*AXXX* BXXX*
APN information can be checked on local telecom website.
You will receive the following text: "Notice: APN is set to XXX. User name: XX. Password:
XX”
4.2 Registering the “Master” Controller
SMS to the device: *master*123456*+1XXXXXXXXXXXX*, (For instance, master
controller phone number is +1XXXXXXXXXXXX. +1 refers to the country code.
XXXXXXXXXXXX is the cellphone number. Please make sure country code is included,
and digit 0 is not needed before cell phone number)
Device Response: "Notice: Cell Phone # xxxxxxxxxx is set to master controller, the
password is 123456.” (The device has a default password of “123456” to initially program
in your PDA/Phone.
NOTE: The device will ONLY listen and respond to instructions from this number unless