Technical data

Installation & Operation Manual GM-TTT
Page 20
6 (data)
Display error counter: disturbances at the genlock signal.
7 (data)
Display internal register for test purposes.
8 (data)
Display internal register for test purposes.
(data)
Display delay between internal and external genlock signal.
(data)
Display period of the external genlock signal.
TEST
(data)
Display delay between second pulse and video or black-burst
genlock signal.
MODE 1
Automatic setting and DST mode of the internal clock.
MODE 2
Time for automatic setting of the internal clock.
1 (data)
Indication of the time of the reference time.
2 (data)
Indication of the date of the reference time.
3 (data)
The last time, when the data of the reference time showed the
"lock" status.
4 (data)
The last date, when the data of the reference time showed the
“lock“ status.
5 (data)
Offset between the reference time and the internal clock.
REFER
6 (data)
Status information resulting from the data of the reference time.
FORMAT
Select the baud rate and format of the serial interface (option).
SERIAL
PROTOCOL
Select the remote control protocol (option).
--
Reserved.
MODE
Settings for the operation mode using external LTC.
OFFSET
Offset programming for the time information.
1 (data)
Indication of the readout LTC time.
2 (data)
Indication of the binary groups of the readout LTC
LTC IN
3 (data)
Indication of the current six flag bits of the readout LTC
SET TIME
Pre-set the comparative time value for GPI relay switching.
GPI
SET MODE
Set the GPI mode.
OFFS 1
Time zone offset during normal time.
OFFS 2
Time zone offset during Daylight Saving Time (DST).
DST on
Program the beginning of the DST.
DST off
Program the end of the DST.
(DST period)
Indicate beginning and end of DST of the current year.
ZONE
RESET A-F
Reset the parameters of the time zones for the timer A - F.