Technical data

Installation & Operation Manual GM-TTT
Page 19
1.7 The Menu Structure, Overview
SET START
Enter a start value of the time code generator.
SET USER
Enter user defined data for the binary groups of the time code.
SET TIME
Set the time of the internal clock.
SET DATE
Set the date of the internal clock.
USER MOD.
Select what kind of information should appear in the binary
groups.
LOCK
Select the genlock and the colour lock mode.
F-RATE
Select frame rate and television system.
PARA
More system parameters.
SET
FACTORY
Factory reset, all current parameters except ‘user area’ and ‘time
zone parameters’ can be reset to default values.
TIME A-F
Select a MTD timer (A ... F or Main Timer 1) and timer mode for
the timer operating mode.
U STORE
All current settings including the parameters set from a MTD
operational unit can be stored to an ‘user area’.
U LOAD
The parameters stored in an ‘user area’ can be loaded, the unit
will be forced to start anew.
U RESET
The parameters stored in an ‘user area’ can be reset to default
values.
A (data)
Display timer A (test purpose only).
B (data)
Display timer B (test purpose only).
C (data)
Display timer C (test purpose only).
D (data)
Display timer D (test purpose only).
E (data)
Display timer E (test purpose only).
TIMER
F (data)
Display timer F (test purpose only).
OUT
Select the LTC output level.
POLARITY
Select the use of the polarity bit.
LTC
1 (data)
Display the six time code flag bits of the LTC generator.
VITC
Enter the VITC set mode.
1 (data)
Display internal register for test purposes.
2 (data)
Display CPU efficiency and ports.
3 (data)
Display current programming of the internal reference signal.
4 (data)
Display error counter: all faulty events of the genlock signal.
STATUS
5 (data)
Display error counter: failures of the genlock signal.