User manual

POWER SETTING

While the set temperature is higher than indoor temperature, the LCD shows and the « »

pattern begins to flick. The heater then works in low-heating mode.

Press the HIGH/LOW button. LCD shows , the sun pattern flicks, the heater starts working in

high-heating speed.

Press the HIGH/LOW button again. LCD shows , the sun pattern flicks, the heater starts

working in low-heating speed.

SWING :

Press the « SWING » button once.

LCD shows flicker. The heater starts swinging.

Press the « SWING » button again, the heater stops swinging.

To turn off the heater, press ON/OFF button.

AUTOMA

TIC CUT-OFF :

This appliance is equipped with an automatic cut-off device in case of overheating or fall.

The appliance restarts automatically when temperature reaches a normal level or when the appliance

is replaced normally.

notice RC_20ET 16/05/06 12:05 Page 13