User manual

USING
Place the heater on a flat and dry surface and plug in it. Two bip sounds are emitted.
ST
ARTING
Press the ON/OFF button. A bip sound is emitted and control panel displays several patterns :
LCD shows and the « » pattern begins to flick : the heater starts working in low-heating
condition. If indoor temperature is higher than the set up temperature, then the heater will
automatically stop blowing hot wind after about 10 seconds. The « » pattern disappear and
the heater starts blowing cold wind.
LCD shows the indoor temperature,
LCD shows – No flicker means no swing function.
LCD shows the « » pattern – Flicker means the anion is working.
TEMPERA
TURE SETTING :
Press once the « MODE » button on the panel control or the remoter.
LCD shows indoor temperature setting flashing.
The heater starting value is 17° C. While the indoor temperature is higher than 17° C, the
micro-computer will control the heater to stop blowing hot wind.
To increase the temperature (up to 35° C), press the « + » button.
To decrease the temperature (to 15° C), press the « - » button .
Should you turn off the heater, the temperature set would de remembered and would be used for next
starting, except if the heater has been turned off in another way.
TIMER SETTING :
Timer is available from 1 to 23h
Press the « MODE » button two time.
Timer an LCD flashes.
Press the « + » button to increase the working time (up to 23h00).
Press the « - » button to decrease the working time (to 1h00).
Press the MODE button a third time when temperature and timing are set up.
12
notice RC_20ET 16/05/06 12:05 Page 12