User manual

INST

ALLA

TION

On the floor :

• Fix the two caster frames (6) at each side

of the heater as shown in the following diagram.

• Chek the caster frames installation before using.

On the wall :

• Mark first screw hole on the wall (about one meter from floor).

• Drill first hole, then insert first screw anchor (12) into the first hole with a hammer.

• Put mounting support (10) on the wall and tighten lightly the first screw (11).

• Mark second screw hole on the wall by raising the support in

parallel to the floor. (at about 158 mm)

• Drill second screw into the second hole and then insert the screw anchor (12).

• Tighten both screws.

• Fix the cover feet

• Place the mounting holes of the support (9) at level of screws. Then the appliance is fixed.

MODE

3 RUNNING MODES :

“LOW” : it runs in low power for the desired time (never use this function without timer)

“HIGH” : it runs in high power for desired time (never use this function without timer)

“AUTO” : set the desired temperature from 7°C to 35°C. If the difference between room temperature and

desired temperature is

- more than 6°C, the appliance runs in high fan heater

- less than 6°C, the appliance runs in low fan heater

HIGH POWER LOW POWER

PR3MBE 1500 1500 W 1000 W

PR3MBE 2000 2000 W 1300 W

OPERA

TING INSTRUCTION

PLUG THE APPLIANCE.

Turn the power switch to 1 position , as sound can be heard.

WITH REMOTE CONTROL OR CONTROL PANEL :

- Press MODE touch. The appliance starts in LOW mode (Its power is 1000 W for PR3MBE 1500 and

1300 W for PR3MBE 2000), the timer is set on 4 hours. To modify selected time, press + or – touch ( from

1 hour to 16 hours). If you select 0h, the appliance stops automatically a few seconds later.

LOW

22°C

TIME 4H

notice PR3MBE 28/03/07 15:58 Page 9