Cut Sheet

Specifications
Housing
Low profile galvanized steel construction
Lamps
Compatible with most one-, two-, three-, and
four-lamp electronic standard and dimming
AC ballasts.
A.L.P.
6333 Gross Point Road, Niles, IL 60714
Ph: [phone] • Fx: [phone]
www.alplighting.com
© 2016 A.L.P. Lighting Components, Inc.
Sheet/REV# EFPSL32GSTD VN081116
EFP SL32GSTD
Emergency Fluorescent Power Pack
General Description
EFP SL32GSTD works with or without
an AC ballast to convert new or existing
fluorescent fixtures into unobtrusive
emergency lighting. They maintain
illumination of one lamp in the emergency
mode for a minimum of 90 minutes.
Features and Benefits
• Provides a minimum of 90 minutes of
emergency illumination
• Can be installed inside, on top of the
fixture or remotely mounted
• Can be used in both switched and
unswitched fixtures
• Includes low voltage LED combo
switch
• Provides a maximum initial lumen
output of 500 lumens
Approvals and Listings
• UL 924 listed for damp locations
• UL listed for retrofit/field installation
• Life safety NFPA 101
• NEC/OSHA
• Suitable for use in sealed and
gasketed fixtures.
Electrical
• Dual voltage input 120V/277 VAC,
60Hz
• Charge rate/power “ON” LED
indicator light and push-to-
test switch for mandated code
compliance testing.
• 4.8V long life, maintenance-free,
rechargeable sealed NiCd battery.
• Internal solid-state transfer switch
automatically connects the internal
battery to fluorescent lamp for
minimum 90-minute emergency
illumination.
• Fully automatic solid-state, two rate
charger initiates battery charging to
recharge a discharged battery in 24
hours.
• Time delay enhancement to
overcome end-of-life circuit
protection.
Warranty
All lighting emergency ballasts are
warranted for a full five (5) years against
defects in material and workmanship
(lamps excluded).
LED Test
switch included.
*Note
When battery packs are remotely
mounted, the remote distance cannot
exceed 1/2 of the distance from ballast
to lamp specified by the A.C. ballast
manufacturer. The maximum allowable
remote mounting distance is 50 feet.
SUITED FOR