Owner Manual

BAND ASSEMBLY
Each band assembly includes the following components:
•  Stainless steel band w/brackets
•  ½” nuts (2)
•  5 1/4” threaded rod
•  Black vinyl caps
Position the bands around your sauna, evenly spaced (45). (On non-canopied barrel saunas the two end bands should cover the nails used to
hold the lower staves in place. On canopy models, evenly spaced bands won’t cover the front nails.) Insert the threaded rod through the bracket
and tighten the nuts by hand evenly until no longer able (46). Before continuing to tighten, verify the bands are evenly spaced and align or
stagger the bracket placement along the side of the sauna according to personal preference. Tighten nuts evenly and place vinyl caps over the
threaded rod (47-48).
Band requirements:
•  4’ and 5’ barrel saunas require two bands
•  6’ barrel saunas require three bands
•  8’ saunas require four bands
•  Grandview and Lewisburg saunas require ve bands
LED LIGHT
Using the provided screws, mount your waterproof power supply where it is most convenient on the exterior of the back sauna panel (49). Run
the female end of the power connection through the panel and connect the two (50). Plug the power source into a standard 110V outlet either
directly or with an extension cord. You may also wish to have your electrician hardwire the light to a 110V circuit.
ACCESSORIES Mount the thermometer on the opposite wall of the heater approximately 12” from the highest point of the barrel.
Install door handle (51-52) Note: Door handles may vary.
BARREL SAUNA INSTALLATION MANUAL
page 6
Image 45 Image 46 Image 47 Image 48
Image 49 Image 50
mount to rear
panel
Image 51 Image 52