Installation & Assembly

AUBURN | BLUESTONE SAUNA INSTALLATION MANUAL
page 5
Step 7. Bench and LED Backrest Installation continued . . .
Center the LED backrest between the two sides being sure it’s oriented so the shorter slat is down and position
it vertically at a height most comfortable for you (typically 8-12” from the bench). Using a level to ensure proper
installation, fasten the backrest into place using the 2” screws (34 & 35). Repeat this process for the lower side bench
backrest (36).
To connect the LED light to the power source, bore a 5/8” hole through the back of the panel at the bottom right
corner of the backrest and push the LED pigtail through (37 & 38). Now mount the power supply to the back of the
sauna at the base of panel C, underneath the hole you just bored (39). Connect the power supply and LED pigtail (40),
and plug in the supply to an outlet. You are able to turn on the LED light and adjust its brightness from within the
sauna using the control mounted to the side of the backrest (41).
Image 34 Image 35 Image 36
Image 37 Image 38 Image 39 Image 40
Image 41