Installation & Assembly
AUBURN | BLUESTONE SAUNA INSTALLATION MANUAL
page 4
Step 6. Assemble and Position Roof Support Rails
Align each roof support rail so the angled cuts join together to make a 90-degree angle placing the longer supports
on the sides and the shorter supports on the front and back. Fasten them together using 2” screws through the pre-
drilled holes (26, 27 & 28). This is the same assembly you performed in Step 2.
Place the assembly on top of the wall panels so that the wall panels t snugly into the groove. When in place, secure
the assembly to the walls using three 2” screws on each rail (29 & 30).
Step 7. Bench and LED Backrest Installation
Note: You may choose to install all the benches and backrests after the sauna is completed, but you may nd it easier
to install with the extra space and light aorded at this step.
Place the upper bench on the pre-installed upper bench supports and push ush against the back wall, being sure the
side of the bench with the screws showing is oriented towards the back (31). Secure the bench to the back and side
panels using 2.5” bench screws and the predrilled holes in the bench frame supports (32).
Repeat this process for the lower side bench (33), securing it to panel A and B.
Image 26 Image 27 Image 28
Image 29 Image 30
Image 31 Image 32
Image 33