Installation & Assembly

AUBURN | BLUESTONE SAUNA INSTALLATION MANUAL
page 2
Step 1. Connect the Four Floor Risers
Fasten the four oor risers together using the predrilled holes as a guide. (1-4)
Step 2. Position Wall Support Rails
Align each wall support so that the angled cuts make a corner (5). Each wall support has a predrilled hole. Fasten the
front, back, and sides together (6 & 7) and lay the assembly squarely on top of the oor risers with the groove facing
up (8). The rails should overlap both sides of the riser by approximately 1” (9). Secure the assembly to the oor risers
using three screws evenly spaced on each wall support rail (10 & 11).
Step 3. Position wall panels A & B
Position wall panel A in the groove of the left rail and push it ush against the back rail. Having a helper hold wall
panel A, orient wall panel B so that the vent holes are on top and place it in the groove of the back rail (12). Push the
at edge against wall panel A. Align the two panels so they are ush and fasten them together using the 2” screws
through the predrilled holes (13 & 14).
Image 1 Image 2 Image 3 Image 4
Image 5 Image 6 Image 7 Image 8
Image 9 Image 10 Image 11
Image 12 Image 13 Image 14