Owner Manual

OPERATING THE HEATER

This heater is operated using two dials – the thermostat and the timer.

Thermostat (left) controls the temperature of the sauna. Set it according to your personal preference.

Timer (right) turns the heater on and o, and has the ability to delay the start.

If the heater has power, you should hear a loud “clunk” at both the 0 and the large 1. In between these “clunks” is one hour of heat time.

Toimmediatelyturntheheateron,werecommendturningthedialpastthetwoclunkstonumber1or2.Turnthetimerbackuntil

oneloud“clunk”isheard,immediatelystoppingtheturn.Thiswillbegintheonehourofheattime.

Theheaterwillautomaticallyshutoafteronehour.Youmayhavetorestartyourheaterwhileyouareinthesauna.

Thesmallernumbers1-8refertothenumberofhoursforthedelaystart.Forexample,ifyouturnthetimerto5,yourheaterwill

begin heating in ve hours.

Withyoursaunadooropen,turnonyourheaterforveminutestoallowthenon-toxicprotectivecoatingontheheating

elementsto“burno”.Itisnormaltoseesomelightsmokeasthiscoatingburnso.

PLACING THE STONES

While the heater is cooling, rinse your sauna stones to prepare them for placement.

Place the smaller stones in between and around the three heating elements being sure that the heating elements do not touch

each other. Thestonesshouldtouchtheelements,butnotbendthem.Reservethelargerstonesforplacementontopofthe

heatingelements,coveringthemcompletely.Replacethestoneguard(21,22).

NOTE:Packingstonesintootightlywillrestrictairowandaecttheeciencyofyourheater.Looselypositionthestonesaround

andabovetheheatingelements.Itiscommontohave5-10stonesleftover.

KIP HEATER INSTALLATION MANUAL

page 5

Image21 Image22

