Instructions / Assembly

ROOM ASSEMBLY continued
With the front and back pieces level and placed, begin placing staves up the sides of the sauna. Tap each board with a rubber mallet (21).
Hammer a 2” nail through every second or third stave into the front and back end panels to keep them from falling out (22). The fewer nails you
use, the easier disassembly will be should you ever need to take down the sauna. Stop using nails about halfway up the sides (23-24).
Note: If you have access to a pneumatic nailer this process will go faster.
BENCHES AND SUPPORTS
Note: You may choose to install benches and supports after the entire room has been assembled, but you may nd installation easier with the
space and light aorded at this point.
Each barrel sauna includes two pre-assembled benches that are side specic. Be sure the shorter bench slat is in front and against the doorframe
(25). Lay the benches on the lower cleats, which are mounted on each end panel (26). Fasten the benches into the cleats using the predrilled
holes (27). Be sure to countersink the fasteners slightly below the surface of the wood. For 6’ and larger barrel saunas, position the provided
centersupportsothatitconnectsthebenchtotheoorofthebarrel.Secureusing2”screwsthroughthepre-drilledholes.(28-29)
Mount the backrests at the level most comfortable to you, typically 8-12” above the bench. Use a level while fastening to ensure an even
installation (30-31).
BARREL SAUNA INSTALLATION MANUAL
page 4
Image 21 Image 22 Image 23 Image 24
Image 25 Image 26 Image 27 Image 28
Image 29 Image 30 Image 31