Instructions / Assembly
ROOM ASSEMBLY
It is now time to assemble the barrel ends. Take the three front end pieces, including the door and two side pieces, and line them up so so that
the A stickers align with each other, and the B stickers align with each other (11-13). Gently position the two wing sections into place on either
side of the door panel - you may use a rubber mallet to achieve a snug t. Secure the wings to the door section with 2” screws through the
predrilled holes on the horizontal support beam (image 14).
Note: the images below show the barrel end being assembled on the ground, but you may choose to assemble it once the door is positioned
intothecrozeoftheoor.
Next, take the three back end pieces and line them up so the C stickers align with each other, and the D stickers align with each other. Gently tap
the two side pieces into the center piece, securing them together using the predrilled holes in the horizontal support beams. (Images 15-16)
Position the front and back ends in the notches, with the horizontal support boards facing the inside of the sauna.
Note: the metal vents are to
be on the bottom on the back end, and the vent holes are to be on the top on the door end (17).
Place a level on the uppermost horizontal support boards on the front and back ends to ensure each end is level (18). Adjust as necessary. Image
(19) shows what your assembly should look like at this point of the installation process.
You will nd it helpful to place a temporary stave at the top, connecting the two ends. This will align and stabilize the two ends while you
continue adding staves to your sauna (20).
BARREL SAUNA INSTALLATION MANUAL
page 3
Image 11 Image 12 Image 13
Image 14 Image 15 Image 16
vents
on top
vents
on bottom
Image 17 Image 18 Image 19
Image 20