Instructions / Assembly

FLOOR ASSEMBLY
Begin assembly by placing the cradles on the ground (1). For optimal assembly, it is important that the cradles are parallel to each other. Fasten
the drain stave directly in the center of the cradles using 2” screws so the stave extends over the end cradles by approximately 4” (2-4). (For barrel
saunas with more than two cradles, space the remaining cradle(s) evenly between the two end cradles. Secure the staves into these cradles
as well.) Make sure the stave sits perpendicular to the cradles before continuing (5). Continue adding staves to each side of the center stave,
tapping each into place with a rubber mallet (6–7). As you are adding staves, fasten every other stave to each cradle making sure each notch
lines up with the others and that each stave is perpendicular to the cradles (8–10).
Note: While cradle placement is the same for both canopy and classic barrel saunas, you may move the front cradle back slightly for canopy
barrel saunas. While unnecessary, it will provide extra support for the door panel.
Image 1 Image 3 Image 4
Image 2
Image 5 Image 6 Image 7
Image 8 Image 9 Image 10
BARREL SAUNA INSTALLATION MANUAL
page 2