Installation Guide

WOOD BURNING HEATER INSTALLATION MANUAL
page 3
1. Place the at wood oor section approximately 4” from rear wall and be sure it is
centered between the benches. NOTE: It is not necessary to anchor it in place.
2. Place the heater “bedding” on the at wood oor section, ensuring that it is centered
on the at oor.
3. After pre-burning the heater outside the sauna, placing it evenly between the
benches and 6” from the rear wall.
4. Place the adaptor pipe on the stove chimney outlet located on the top of the stove.
NOTE: remove the cover from the outlet and then place it on the rear heater outlet.
You may need to remove a metal covering secured by a single screw to access the rear
outlet.