Installation Guide

Step 1. Connect the Four Floor Risers
Fasten the four oor risers together using the predrilled holes as a guide, being sure the two shorter boards are located on the sides and the
two longer boards are on the front and back. Use a framing square to ensure the assembly is square. (Images 1-5)
Step 2. Position Wall Support Rails
Align each wall support so that the angled cuts make a corner (Images 6 & 7), placing the shorter supports on the sides and the longer supports
on the front and back. Each wall support has a predrilled hole. Fasten the front, back and sides together (Images 8 & 9) and lay the assembly
squarely on top of the oor risers with the groove facing up (Image 10). The rails should overlap both sides of the riser by approximately 1”
(Image 11). Secure the assembly to the oor risers using three screws evenly spaced on each wall support rail (Images 12 & 13).
Step 3. Position wall sections A & B
Position wall section A in the groove of the left rail and push it ush against the back rail (Images 14 & 15). Having a helper hold wall section A,
orient wall section B so that the vent holes are on top and place it in the groove of the back rail (Image 16). Push the at edge ush against wall
section A. Align the two panels so they are ush and fasten them together using the 2” screws (Images 17 & 18).
Image 1 Image 2 Image 3 Image 4 Image 5
Image 6 Image 7 Image 8 Image 9
Image 10 Image 11 Image 12 Image 13
Image 14 Image 15 Image 16 Image 17 Image 18
BRIDGEPORT | BRAXTON SAUNA INSTALLATION MANUAL
page 2