Owner Manual

STEP 19 - You will now install the bench
supports. Find the long bench support and cut to
length so that it will go as far as the left and right
walls. On the rear wall and from the oor measure
33” and make a pencil mark. Position the upper
bench support at (just below) the mark and use
a level to insure that the support is level to the
ground. Then screw the upper bench support
into the wall element sections using 5x70 screws.
Do this with both the short right and left bench
supports as well.
STEP 20 - Place the upper bench onto the
upper bench supports. Once the upper bench is
in place, secure the rear and sides of the bench to
the wall sections from below using 4x60 screws.
Place one screw
into each wall
element section.
STEP 21 - Attach the side upper bench
support to the side wall by lining up to the
rear side bench support. Screw into place
with 5x70 screws insuring that the support is
level.