Owner Manual
STEP 16 - Locate the glass wall header and position over the
glass window sections. Lower the header over the glass so that
the glass will t into the grooves at the base of the header. Line
up the pins of the header to
the holes in the corner posts
and gently tap into place with a
rubber mallet. NOTE: YOU MAY
NEED TO PULL THE LEFT AND
RIGHT WALLS OUT SLIGHTLY
IN ORDER TO FIT THE HEADER
BETWEEN THEM. DO
NOT USE GLUE WHEN
TAPPING THE PINES
INTO THE HOLES.
STEP 17 - The sauna room should now have all wood and
glass wall sections in place and ready for the roof installation.
STEP 18 - From the top of the sauna lay the (3)
roof element sections in place. The side to face “up”
is indicated, and the front roof section will t into the
groove of the header, and the rear roof section has a
smooth edge. Once the roof sections are in place you
can screw them to the roof support rails with 5x70
screws.
Note: The center roof section is the one with tongue
and groove proles on both long sides.