Owner Manual

STEP 13 - You will now install the roof support rails.
Locate the (3) roof support rails and cut to length. The
left and right rails should butt up to the front corner posts
and the rear wall. NOTE: BE SURE THERE ARE NO GAPS
BETWEEN THE WOOD WALL ELEMENTS BEFORE TAKING
YOUR MEASUREMENTS.
Measure 1-1/2” down from the top of the wall element
sections and pencil marks on each end the wall sections.
Then screw the roof support rails to the wall element sec-
tions using 4x70 screws with the bit provided. Secure the
roof support rails to the wall element sections by screw-
ing a 4x70 screw into each wall element section. This will
rmly secure the wall element sections together along the
three wood walls of the sauna.
STEP 14 - The sauna will wood wall sections
will now be securely in place and held together by
means of the attached roof support rails.
STEP 15 - Locate the two glass window
sections noting that one of them has holes
for the door hinges. The instructions show
installation with the door opening from left to
right, but you can reverse by switching the
glass window sections.
Place one of the metal glass support rails
below the glass and then slide the glass
into the groove on the corner post. Repeat
for the opposite side taking care to hold the
glass in place so that it does not fall prior to
securing in place.