Owner Manual

STEP 4 - Verify that the element wall sections are square to the rails, perpendicular to each
other, and that the at top of the wall elements and corner posts align.
Using a cordless drill with the appropriately sized bit (included) use 6x20 screws and secure the
90° corner post to the short and wide elements through the pre-drilled holes.
NOTE: Because the elements utilize both vertical and horizontal boards, you will hear a cracking”
sound as you draw the elements tight with the screw. This is normal and will not result in any
splitting of the wood.
STEP 5 - Place the next 2 element sections on the
right side wall. There will be no screws used in these
elements, but be sure the elements are rmly placed
to the bottom rail and that the at top sections are
ush to each other. NOTE: THE FRONT ELEMENT
SECTION ON THE RIGHT SIDE WILL HAVE 3 CLIPS
ALONG ONE EDGE. THESE SHOULD FACE THE FRONT
OF THE SAUNA.
STEP 6 - Locate one of the 90° corner posts that has clips on one side and a glass groove with
2 holes on the other. Be sure the holes are to the top and facing towards the inside of the sauna.
Line up the side with the post with clips to the element section with clips. Raise the post several
inches above the wall element before pushing into place.
Then gently tap the post into the element section so that
the clips align.
NOTE: The clips allow the wall sections to connect
securely and rmly without the use of screws, but
everything must line up for them to t correctly. You
must position the 90° corner post several inches above
the wall section before nesting the post to the wall. The
clips will slide into each other and hold the post. If the
clips will not easily slip together, then take a Phillips head
(+) screwdriver and loosen the screws holding all of the
clips by ½ turn and try again. Loosening the clip slightly
will not aect the holding power of the clip but will allow
them to connect easier.
Clip
Glass groove