Owner Manual

STEP 1 - Locate the (3) bottom rails
and position as shown. Overlap the corner
joints and be sure the rails are square to
each other. Drill a 1/8” pilot hole in the
corner joints and secure rails to each other
using a single 5x70 screw in each of 2
corners.
STEP 2 - Locate the wood wall
elements (sections). These will be
inserted over the bottom rails as shown
in the diagram.
STEP 3 - Find the wall element with the square hole and
position on the right rear of bottom rail. NOTE: If the heater
is going to be installed on the right wall then positing the
element with the square hole on the left rear. (On all wall
elements the at edge is the top and the groove that will t
over the tongue on the bottom rails is on the bottom.) With
one person holding this wall element have another person
position one of the 90° corner posts and then another
wall element section on the rail perpendicular to the rst
element section.
NOTE: It is helpful to tap the elements to each
other, to the corner piece, and to the bottom
rail using a rubber mallet.
Wall Element Sections
W=Wood
P=Post
G=Glass
D=Door
PW=Post Wider