Owner Manual

ELECTRICAL REQUIREMENTS
All electrical wiring must be performed by A QUALIFIED LICENSED ELECTRICIAN. Because of the heat involved in the sauna, it is required that
you use copper wire with 90ºC insulation. Do not use aluminum wire to make the connection. Consult with an electrician so you can determine
the requirements for your particular situation. All wiring must conform to all national, state and local codes and regulations and according to the
instructions provided with the heater.
Be sure the surface where you are placing the sauna is at and level. A concrete, tile, vinyl, laminate or similar surface is suitable; placing the
sauna on carpet is not recommended. It is suggested that you lay out all of the components so that it is easy to identify the pieces once you get
started with assembly.
You will need the following tools to assemble your Patterson Sauna:
Rubber mallet
Hand saw
Hammer
Cordless drill
Stepladder
Level
Square
Tape measure
You will nd the following wood components as well as labeled bags of screws and hardware.
3 – Bottom rails
2 – 90° Corner wall posts
2 – 90° Corner wall posts for glass walls
10 – Wood wall element sections
2 – Glass windows
1 – Glass door
2 – Glass support rails
1 – Glass wall header
1 – Metal post bench support bracket
1 – Metal post bench support
2 – Long roof support rails
2 – Short roof support rails
3 – Roof element sections (labeled as to which side to put facing up)
2 – Top bench supports (Approximately 23” long)
1 – Lower bench support for long right wall (Approximately 47” long)
1 – Lower bench support for short window wall (Approximately 52” long)
1 – Upper bench
1 – Lower bench
1 – Upper bench support for side bench (Approximately 23” long)
1 – Upper side bench
2 – Upper bench back supports
1 – Lower bench back support
1 – Vent cover
4 – Exterior roof trim
1 – Heater fence kit
NOTE: It is recommended that two people do the assembly of the sauna.
These instructions explain assembly with the door swinging to the right and with the heater on the left wall of the sauna. You can assemble the
sauna with the heater on the right and/or the door swinging to the left. If you choose to invert the assembly then be sure to do all assembly
opposite of the directions shown.
Read this entire manual through to the end before proceeding with the assembly.
Almost Heaven Saunas
THE AUTHENTIC SAUNA EXPERIENCE
®