Owner Manual

STEP 28 - Assemble the lower
bench by attaching the right and
left framed leg supports to the
bench and screwing into place
with 4x60 screws. Be sure the
two holes in the uprights are to
the rear of the bench and the
plastic oor protectors are down.
Next, attach the angled support
members so that the pins line
up with the holes. Place a dab of
wood glue (not included) in the
holes before tapping into place.
Secure the support members to
the bench using 3.5x40 screws.
STEP 29 - Locate the vent cover and position
over the wall opening. Attach with (40) 3.5x40
screws.
STEP 30 -
Locate the exterior roof trim pieces. These will attach
to the exterior top perimeter of the sauna. The pieces create an “L
around the top edge and will be screwed to the roof sections from
the top using 3.5x40 screws. NOTE: The trim pieces are not pre-cut
and must be cut to size using a hand saw. If the sauna is being placed
the corner of the room then it
is common to only install the
trim on the visible sides. The
trim piece that is placed over
the front header will require a
portion of the tongue to be cut
away.