Owner Manual

STEP 25 - You will now install the lower bench back
support. From the front of the two UPPER bench supports
that you just installed, measure 1-1/2” back and make a
mark. Then, install the two lower backrest supports (one
on the left and right side of the sauna) to the sidewall
element sections using 5x70 screws.
STEP 26 - Position the lower back support
(5-slats) against the vertical supports you
installed in step 25. Holding the lower bench
support tight to the top bench, attach to the
vertical supports using 3.5x40 screws.
STEP 27 - Measure 10” above the rear and
side upper benches and make a pencil mark.
Place one of the upper bench back supports
(3-slats on each back support) above each
bench and be sure it is level. Then, using 3.5x40
screws attach the back support to the wall
element sections. Position your screws in the
vertical battens between the slats so that the
screws are concealed.