ALM-007 - ‘Boss Bow Tie’ ALM-007 ‘Boss Bow Tie’ - Operation Manual -
Introduction ...........................................................................................3 Technical Specifications .......................................................................................3 Core Operation.......................................................................................4 Panel Layout .........................................................................................................4 General Usage.......................................................
ALM-007 - ‘Boss Bow Tie’ Introduction ‘Boss Bow Tie’ is an 8 way bidirectional voltage controlled switch. An input ‘I/O’ signal is mapped to an output ‘I/O’ via a corresponding control voltage. As bidirectional, this can be either 1 of up to 8 inputs into a single output or a single input into 1 of up to 8 outputs. The control input features both an attenuverter and offset to precisely select which of the 8 I/O’s are available to be ‘switched’.
ALM-007 - ‘Boss Bow Tie’ Core Operation Panel Layout BOSS BOW TIE I/O I/O Single signal I/O Gate input. Low disables switch, high enables (normalised to high) Gate ol ntr Co 8 mappable signal I/O’s Offset Offset knob to add an offset voltage to control signal -|+ Attenuverter knob to attenuate/invert control signal Control signal input.
ALM-007 - ‘Boss Bow Tie’ General Usage ‘Boss Bow Tie’ is an 8 way bidirectional voltage controlled switch. The switch connects the left ‘I/O‘ to one of the right “I/O’s allowing a signal to then flow in either direction. Which of the I/O’s are ‘connected’ is dependent on a control voltage applied to the control input together with the offset and attenuverter setting. The offset adds a voltage to the incoming control voltage.
ALM-007 - ‘Boss Bow Tie’ Patch Ideas Voltage Controlled Transposition - Patch CV sequence to be transposed into Beast’s Chalkboard top ‘In’. Patch Thru output to Boss Bow Tie (BBT) top right I/O, patch Chalkboard top section output to 2nd BBT right I/O, patch lower section Beast output to 3rd BBT I/O. Set Chalkboard dials to required transposition octaves. Patch BBT left single I/O to Oscillator pitch input. Patch control signal (ie from LFO/other sequencer etc) to BBT control input.
ALM-007 - ‘Boss Bow Tie’ Limited Warranty From the date of manufacture this device is guaranteed for a period of 2 years against any manufacturing or material defects. Any such defects will be repaired or replaced at the discretion of ALM. This does not apply to; • Physical damage arising for mistreating (i,e dropping, submerging etc). • Damage caused by incorrect power connections. • Overexposure to heat or direct sunlight. • Damage caused by inappropriate or mis-use.
ALM-007 - ‘Boss Bow Tie’ Support For the latest news, additional info, downloads and firmware updates please visit the ALM website at http://busycircuits.com and follow @busycircuits on twitter. Please send any questions or comments to info@busycircuits.
