System information

System Administration Guide

Most of the configuration options on this page should be comprehensible after reading the

Call Routing

Concepts

section above. Some additional explanation follows.

Notice the presence setting displayed near the top of the page. Next to it is a checkbox to apply changes

made here to all presences. If this call route has no Caller-ID pattern specified (it is the all calls call route),

then this call route is copied to the all calls call route in all the other presences. If this call route has a Caller-

ID pattern specified, it is copied to the same Caller-ID patterned call routes in the other presences, creating

new call routes if necessary.

To delete a phone from a connection attempt, choose no selection from the Call Appearance drop down list.

To set up a connection attempt so it properly participates in the ringing of a Line Appearance PFK on an

Allworx

IP phone, select Key System Ring Delay from the Call Appearance drop down list. See XXX for more

information.

Recall that the on-busy route is optional. An inactive on-busy route is one with no connection attempts and a

finally clause set to Hang up. To make it active, add one or more connection attempts and/or change the

finally clause. To make it inactive again, just change it back to the inactive state (delete all connection

attempts and set the finally clause to Hang up).

300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com

Revised: March 28, 2007

Page 70