System information

System Administration Guide
As instructed on the page, enter the firewall’s public IP address in the Public IP Address field. Furthermore,
the firewall must be configured to statically map specific ports through the firewall to the Allworx
server. This
is described in the NOTE box on the web page specific to your server’s configuration.
14.3 Remote Allworx IP Phone
14.3.1 Configuration
Configuration of the remote phone requires setting two configuration parameters in the phone itself. Both are
found in the Config / Network Settings menu on the phone.
The first parameter is the Boot Server IP. This is normally the IP address of the Allworx
server’s WAN port
which can be obtained from the server’s WAN TCP/IP Address parameter on the Network / Configuration
page. However, if the Allworx
server network mode is set to LAN Host, then this value will be the Public IP
Address parameter on the Network / Configuration page.
The second parameter needed in the phone is the Remote Plug and Play Key (called Remote Plug ‘n’ Play
on the phone menu). This key is obtained from the Servers / VOIP Server page. You will see a page like
this:
300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com
© 2007 InSciTek Microsystems, Inc. All rights reserved. Allworx is a registered trademark of InSciTek Microsystems.
Revised: March 28, 2007
Page 60